Allied Telesis AT-S62 - Manual (Page 232)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 232
SNMPv3 Community Table
The Configure SNMPv3 Community Table Menu allows you to configure
SNMPv1 and SNMPv2c communities. If you are going to use the SNMPv3
Tables to configure SNMPv1 and SNMPv2c communities, start with the
SNMPv3 Community Table. See Configuring the SNMPv3 Community
Table on page 309.
Note
Allied Telesyn recommends that you use the procedures described
in Chapter 5: SNMPv1 and SNMPv2c Configuration on page 81 to
configure the SNMPv1 and SNMPv2c protocols.
SNMPv3
Configuration
Example
You may want to have two classes of SNMPv3 users—Managers and
Operators. In this scenario, you would configure one group, called
Managers, with full access privileges. Then you would configure a
second group, called Operators, with monitoring privileges only. For a
detailed example of this configuration, see Appendix B, SNMPv3
Configuration Examples on page 843.