Allied Telesis AT-S62 - Manual (Page 577)

AT-S62 User’s Guide
Section VIII: Web Browser Management 577
Saving Your Parameter Changes
When you make a change to a switch parameter, the change is, in most
cases, immediately activated as soon as you click the Apply button.
However, a change to a switch parameter is initially saved only to
temporary memory. It is lost the next time you reset or power cycle the
unit. To permanently save a change, you must click the Save Changes
button. This button is located on the General tab.
To locate the button, from the Home Page click Configuration. The
General tab is displayed. The Save Changes button is at the bottom of
the page. If the button is not visible, there are no changes for the switch
to save.
Figure 190 Save Changes Button in the General Tab (Configuration)
Save Changes Button