Allied Telesis AT-S62 - Manual (Page 305)

AT-S62 User’s Guide
Section III: SNMPv3 Operations 305
2-v2c
Select this value if this User Name is associated with the SNMPv2c
protocol.
3-v3
Select this value if this User Name is associated with the SNMPv3
protocol.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Security Level
For the Security or User Name you have selected, the value of the
Security Level parameter in an SNMPv3 Target Parameter Table entry
must match the value of the Security Level parameter in the SNMPv3
User Table entry.
To modify the Security Level parameter in an SNMPv3 Target Parameter
Table entry, perform the following procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71 on page
235.
2. From the Configure SNMPv3 Table Menu, type 8 to select Configure
SNMPv3 Target Address Table.
The Configure SNMPv3 Target Parameters Table Menu is shown in
Figure 84.
3. From the Configure SNMPv3 Target Parameters Table Menu, type 3 to
select Modify SNMPv3 Table Entry.
The Modify SNMPv3 Target Parameters Table Menu is shown in
Figure 85 on page 303.
4. To modify the Security Level, type 3 to select Set Security Level.
The following prompt is displayed:
Enter Target Parameters Name:
5. Enter a previously configured Target Parameters Name.
Enter a value of up to 32-alphanumeric characters.
The following prompt is displayed:
Enter Security Level [N-NoAuthNoPriv, A-AuthNoPriv,
P-AuthPriv]:
6. Enter the Security Level.