beautypg.com

Figure 11: configure system time menu – Allied Telesis AT-S62 User Manual

Page 68

background image

Chapter 4: Basic Switch Parameters

Section I: Basic Operations

68

The Configure System Time menu is shown in Figure 11.

Figure 11 Configure System Time Menu

4. To set the system time manually, do the following:

a. Type 1 to select System Time

The following prompt appears:

Enter new system time [hh:mm:ss] ->

b. Enter a new time for the system in the following format: hours,

minutes, and seconds all separated by colons.

The following prompt appears:

Enter new system date [dd-mm-yyyy] ->

c. Enter a new date for the system. Use two numbers to specify the

day and month. Use four numbers to specify the year. Separate
the values with hyphens. For example, December 5, 2003 is
specified 05-12-2003.

The new time and date are immediately activated on the
switch.

5. To configure the switch to obtain its date and time from an SNTP or

NTP server on your network or the Internet, do the following:

a. Type 3 to select SNTP Server to enter the IP address of an SNTP

server.

Allied Telesyn Ethernet Switch AT-8524M - AT-S62

Production Switch

User: Manager

11:20:02 02-Jan-2004

Configure System Time

1 - System Time ................... 00:04:22 on 01-Jan-1970
2 - SNTP Status ................... Disabled
3 - SNTP Server ................... 0.0.0.0
4 - UTC Offset .................... +0
5 - Daylight Savings Time (DST) ... Enabled
6 - Poll Interval ................. 600 seconds
7 - Last Delta .................... +0 seconds

U - Update System Time
R - Return to Previous Menu

Enter your selection?