Allied Telesis AT-S62 - Manual (Page 724)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 724
A warning message is displayed. Click OK to remove the Target
Parameters Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
Target
Parameters
Table Entry
To modify an SNMPv3 Target Parameters Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Parameters Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Parameters Table Page is shown in Figure 251
on page 720.
4. Click the circle next to the Target Parameters Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Target Parameter Table Page is shown in
Figure 253 on page 724.
Figure 253 Modify SNMPv3 Target Parameters Table Page