Allied Telesis AT-S62 - Manual (Page 731)

AT-S62 User’s Guide
Section VIII: Web Browser Management 731
Modifying an
SNMPv3
Community
Table Entry
To modify an entry in the SNMPv3 Community Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Community Table. Then click Configure at the bottom of the page.
The SNMPv3 Community Table Page is shown in Figure 254 on
page 728.
4. Click the circle next to the SNMPv3 Community Table entry that you
want to change. Then click Modify.
The Modify SNMPv3 Community Table Page is shown in Figure
256.
Figure 256 Modify SNMPv3 Community Table Page
5. In the Community Name field, enter a Community Name of up to 64-
alphanumeric characters.
The value of the Community Name parameter acts as a password
for the SNMPv3 Community Table entry. This parameter is case
sensitive.
Note
Allied Telesyn recommends that you select SNMP Community
Names carefully to ensure these names are known only to
authorized personnel.