Allied Telesis AT-S62 - Manual (Page 686)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 686
13. Click Apply to update the SNMPv3 User Table.
14. To save your changes, return to the General Tab and click Save
Changes.
Deleting a User
Table Entry
To delete an entry in the SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure.
The SNMPv3 User Table Page is shown in Figure 233 on page 683.
4. Click the circle next to the User Table entry that you want to delete.
Then click Remove.
A warning message is displayed. Click OK to remove the User
Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
User Table
Entry
To modify an entry SNMPv3 User Table, perform the following
procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
User Table. Then click Configure.
The SNMPv3 User Table Page is shown in Figure 233 on page 683.
4. To modify an SNMPv3 User Table entry, click the circle next to the
SNMPv3 user that you want to change. Then click Modify.