Allied Telesis AT-S62 - Manual (Page 65)

AT-S62 User’s Guide
Section I: Basic Operations 65
Configuring the Manager and Operator Passwords
There are two levels of management access on an AT-8524M switch:
manager and operator. When you log in as manager, you can view and
configure all of a switch’s operating parameters. When you log in as an
operator, you can only view the operating parameters; you cannot
change any values.
You log in as a manager or an operator by entering the appropriate
username and password when you start an AT-S62 management
session. The default password for manager access is “friend”. The default
password for operator access is “operator”. Passwords are case-sensitive.
To change the manager or operator password, perform the following
procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 59.
2. From the System Administration menu, type 6 to select
Authentication Configuration.
3. From the Authentication Configuration menu, type 5 to select
Passwords Configuration.
The Passwords Configuration menu is shown in Figure 10.
Figure 10 Passwords Configuration Menu
4. Type 1 to change the Manager password or type 2 to change the
Operator password.
5. When prompted, enter the current manager password. (This step
does not apply for the operator password.)
6. When prompted, enter the new manager or operator password. The
new password will be case-sensitive.
7. When prompted, re-enter the new password.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Passwords Configuration
1 - Set Manager Password
2 - Set Operator Password
R - Return to Previous Menu
Enter your selection?