Allied Telesis AT-S62 - Manual (Page 690)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 690
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
❑ Creating a View Table Entry on page 690
❑ Deleting a View Table Entry on page 693
❑ Modifying a View Table Entry on page 694
For reference information about the SNMPv3 View Table, see
Configuring the SNMPv3 View Table on page 690.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table entry, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
View Table. Then click Configure at the bottom of the page.
The SNMPv3 View Table Page is shown in Figure 236.
Figure 236 SNMPv3 View Table Page