Deleting an snmpv3 user table entry, Modifying an snmpv3 user table entry – Allied Telesis AT-S62 User Manual
Page 238
Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations
238
Note
The Row Status parameter is a read-only field in the Telnet and Local
interfaces. The Active value indicates the SNMPv3 User Table entry
takes effect immediately.
12. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 User
Table Entry
You may want to delete an entry from the SNMPv3 User Table. When you
delete an entry in the SNMPv3 User Table, there is no way to undelete, or
recover it.
To delete an entry in the SNMPv3 User Table, perform the following
procedure.
1. Follow steps 1 through 3 in the procedure described in Creating an
SNMPv3 User Table Entry on page 234. Or, from the Main Menu type
5->5->5.
The Configure SNMPv3 Table Menu is shown in Figure 71.
2. From the Configure SNMPv3 Table Menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 72.
3. From the SNMPv3 User Table, type 2 to select Delete SNMPv3 Table
Entry.
The following prompt is displayed:
Enter User (Security) Name:
4. Enter the User Name of the User Table entry you want to delete.
The following prompt is displayed:
Do you want to delete this table entry? (Y/N):
[Yes/No]->
5. Enter Y to delete the user or N to save the user.
6. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying an
SNMPv3 User
Table Entry
This section describes how to modify parameters in an SNMPv3 Notify
Table entry. See the following procedures:
❑ Modifying the Authentication Protocol and Password on page