Allied Telesis AT-S62 - Manual (Page 717)

AT-S62 User’s Guide
Section VIII: Web Browser Management 717
Modifying
Target Address
Table Entry
To modify an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Address Table Page is shown in Figure 248 on
page 714.
4. Display the Target Address Table entry that you want to change.
Click Next or Previous to display an entry.
5. Click Modify.
The Modify SNMPv3 Target Address Table Page is shown Figure
250.
Figure 250 Modify SNMPv3 Target Address Table Page
6. In the IP Address field, enter the IP address of the host.
Use the following format for an IP address:
XXX.XXX.XXX.XXX