Allied Telesis AT-S62 - Manual (Page 798)

Chapter 50: Secure Shell Protocol
Section VIII: Web Browser Management 798
Configuring the SSH Server
This section describes how to configure the SSH server software on the
switch. For an overview of all the steps to configuring the SSH server, see
General Steps to Configuring SSH on page 547.
This procedure assumes that you have already created the two key pairs.
If you have not created the keys, go to Creating an Encryption Key on
page 500. You cannot create encryption keys from a web browser
management session.
Prior to configuring the SSH feature, you must disable the SSH server.
When you have completed your configuration changes, enable the SSH
server to permit SSH client connections.
Note
Allied Telesyn recommends disabling the Telnet server before
activating SSH. Otherwise, the security functions provided by SSH
are lost. See Enabling or Disabling the Telnet Server on page 73.
To configure the SSH server software on the switch, perform the
following procedure:
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. Click Security.
3. Select the Secure Shell tab. The Secure Shell tab is shown in Figure
291.
Figure 291 Secure Shell Tab (Configuration)