Allied Telesis AT-S62 - Manual (Page 706)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 706
The SNMPv3 SecurityToGroup Table Page is shown in Figure 242
on page 703.
4. Click the circle next to the SecurityToGroup Table entry that you want
to delete. Then click Remove.
A warning message is displayed. Click OK to remove the SNMPv3
SecurityToGroup Table entry.
5. To save your changes, return to the General Tab and click Save
Changes.
Modifying a
SecurityToGroup
Table Entry
To modify an entry SNMPv3 SecurityToGroup Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
SecurityToGroup Table. Then click Configure at the bottom of the
page.
The SNMPv3 SecurityToGroup Table Page is shown in Figure 242
on page 703.
4. Click the circle next to the SecurityToGroup Table entry that you want
to change. Then click Modify.
The Modify SNMPv3 SecurityToGroup Page is shown in Figure
244.
Figure 244 Modify SNMPv3 SecurityToGroup Page