Allied Telesis AT-S62 - Manual (Page 270)

Chapter 17: SNMPv3 Configuration
Section III: SNMPv3 Operations 270
The following prompt is displayed:
Enter Group Name:
6. Enter a Group Name that you configured in the SNMPv3 Access Table.
See. Creating an SNMPv3 Access Table Entry on page 253.
There are four default values for this field:
❑ defaultV1GroupReadOnly
❑ defaultV1GroupReadWrite
❑ defaultV2cGroupReadOnly
❑ defaultV2cGroupReadWrite
These values are reserved for SNMPv1 and SNMPv2c
implementations.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 SecurityToGroup Table to the configuration
file. After making changes to an SNMPv3 SecurityToGroup Table
entry with a Volatile storage type, the S - Save Configuration
Changes option does not appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 SecurityToGroup Table to the configuration file. After
making changes to an SNMPv3 SecurityToGroup Table entry with
a NonVolatile storage type, the S - Save Configuration Changes
option appears on the Main Menu, allowing you to save your
changes.
Note
The Row Status parameter is a read-only field in the Telnet and Local
interfaces. The Active value indicates the SNMPv3 SecurityToGroup
Table entry will take effect immediately.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.