Allied Telesis AT-S62 - Manual (Page 569)

AT-S62 User’s Guide
Section VII: Management Security 569
on the address. For example, to allow all management workstations
in the subnet 149.11.11.0 to manage the switch, you would enter the
mask 255.255.255.0.
This prompt is displayed:
Enter the Protocol [TCP/UDP/ALL]:
6. Enter either TCP or ALL.
The software allows you to select UDP. But since AT-S62
management packets from Telnet and web browser management
sessions are TCP, you must specify TCP or ALL.
This prompt is displayed:
Enter the Interface [TELNET/WEB/ALL]:
7. Specify which interface you want a remote management workstation
to be able to use when managing the switch. Your choices are:
❑ Telnet - Permits Telnet management.
❑ Web - Permits web browser management.
❑ All - Permits both Telnet and web browser management.
8. If needed, repeat this procedure starting with Step 3 to add more
ACEs to the Management ACL.
9. After you have added all of the ACEs, type 1 to select Management
ACL Status and toggle the selection to Enabled.
Note
If you activate this feature without specifying any ACEs, all Telnet
and web browser management packets are discarded by the switch,
making it impossible for you to remotely manage the device.
The Management ACL is now active on the switch.
10. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.