Allied Telesis AT-S62 - Manual (Page 640)

Chapter 38: Port Mirroring
Section VIII: Web Browser Management 640
Figure 216 shows an example of the Modify Mirror page
configured for a port mirror. The egress traffic on Ports 11 and 12
is being mirrored to the destination Port 5.
Figure 216 Example of a Modify Mirror Page
6. After selecting the destination and source ports, click the Enable
Mirror check box.
7. Click Apply.
The port mirror is now active on the switch. You can connect a
data analyzer to the destination port to monitor the traffic on the
source ports.
8. To permanently save the change, use the Save Changes button in the
General tab. For directions, refer to Saving Your Parameter Changes
on page 577.