Allied Telesis AT-S62 - Manual (Page 64)

Chapter 4: Basic Switch Parameters
Section I: Basic Operations 64
Rebooting a Switch
This procedure reboots the switch.
Note
Any configuration changes not save will be lost once the switch
reboots. To save your configuration changes, return to the Main
Menu and type S to select Save Configuration Changes.
To reboot the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 59.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9.
Figure 9 System Utilities Menu
3. From the System Utilities menu, type 5 to select Reboot the switch.
The following prompt is displayed:
The switch is about to reboot. Do you want to
proceed? [Yes/No] ->
4. Type Y to reboot the switch or N to cancel the procedure.
Caution
The switch will not forward traffic while it initializes its operating
software, a process that takes approximately 20 seconds to
complete. Some packet traffic may be lost. Once the switch is
finished rebooting, you will need to reestablish your management
session if you want to continue managing the unit.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
System Utilities
1 - File Operations
2 - Downloads and Uploads
3 - Ping a remote system
4 - Reset to Factory Defaults
5 - Reboot the switch
R - Return to Previous Menu
Enter your selection?