Allied Telesis AT-S62 - Manual (Page 581)

AT-S62 User’s Guide
Section VIII: Web Browser Management 581
Note
If the window does not have an Enhanced Stacking tab, you are
attempting to change the stacking status of a switch accessed
through enhanced stacking. This is not allowed. The only stacking
status you can change remotely from a web browser management
session is the switch on which you started the session.
The Enhanced Stacking tab is shown in Figure 191.
Figure 191 Enhanced Stacking Tab (Configuration)
4. Click the desired enhanced stacking status for the switch. The default
is Slave.
5. Click Apply.
The new enhanced stacking status is immediately activated on
the switch.
6. To permanently save the change, click Save Changes in the General
tab of the System page. For directions, refer to Saving Your Parameter
Changes on page 577.