Allied Telesis AT-S62 - Manual (Page 716)

Chapter 44: SNMPv3 Protocol
Section VIII: Web Browser Management 716
NonVolatile
Select this storage type if you want the ability to save an entry in
the Target Address Table to the configuration file. After making
changes to a Target Address Table entry with a NonVolatile
storage type, Save Changes appears on the General Tab.
Note
The Row Status parameter is a read-only field in the Web interface.
The Active value indicates the SNMPv3 Target Address Table entry
takes effect immediately.
13. Click Apply to update the SNMPv3 Target Address Table.
14. To save your changes, return to the General Tab and click Save
Changes.
Deleting a
Target Address
Table Entry
To delete an entry in the SNMPv3 Target Address Table, perform the
following procedure.
1. From the Home Page, select Configuration.
The Configuration System Page is displayed with the General Tab
selected by default, as shown in Figure 194 on page 586.
2. Select the SNMP Tab.
The SNMP Tab is shown in Figure 198 on page 599.
3. In the SNMPv3 section of the page, click the circle next to Configure
Target Address Table. Then click Configure at the bottom of the
page.
The SNMPv3 Target Address Table Page is shown in Figure 248 on
page 714.
4. Display the SNMPv3 Target Address Table entry that you want to
delete.
Click Next or Previous to display an entry.
5. Click Remove.
A warning message is displayed. Click OK to remove the Target
Address Table entry.
6. To save your changes, return to the General Tab and click Save
Changes.