Allied Telesis AT-S62 - Manual (Page 596)

Chapter 33: Basic Switch Parameters
Section VIII: Web Browser Management 596
Returning the AT-S62 Software to the Factory Default Values
The procedure in this section returns all AT-S62 software parameters,
including IP address and subnet mask, if assigned, to their default values.
Please note the following before performing this procedure:
❑ Returning all parameter settings to their default values also
deletes any port-based or tagged VLANs you created on the
switch.
❑ This procedure does not delete files from the AT-S62 file system.
To delete files, refer to Chapter 11, File System on page 146.
❑ This procedure does not delete encryption keys stored in the key
database. To delete encryption keys, refer to Deleting an
Encryption Key on page 504.
❑ Returning a switch to its default values does not alter the contents
of the active boot configuration file. To reset the file back to the
default settings, you must select the Save Changes button from
the System tab after the switch reboots and you have
reestablished your management session. Otherwise the switch
will revert back to the previous configuration the next time you
reset the unit.
Note
The AT-S62 software default values can be found in Appendix A,
AT-S62 Default Settings on page 820.
To return the AT-S62 management software to the default settings,
perform the following procedure:
1. From the Home Page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 194 on page 586.
2. Select the System Utilities tab.