Allied Telesis AT-S62 - Manual (Page 184)

Chapter 13: Event Log
Section II: Advanced Operations 184
Enabling or Disabling the Event Log
To enable or disable the event log, do the following:
1. From the Main Menu, type 5 to select System Administration.
2. From the System Administration menu, type 8 to select Event Log.
The Event Log menu is shown in Figure 53.
Figure 53 Event Log Menu
3. Type 1 to toggle Log Status between the two selections Enabled and
Disabled. If you enable the log, the system immediately begins to add
events in the log. The default is enabled.
4. Type 2 to toggle Log Full Action between the two selections Wrap
and Halt. The Wrap option causes the log to delete old entries as it
adds new entries once it reaches its maximum capacity of 4,000
events. The Halt option causes the log to stop adding new entries
once it reaches maximum capacity. The default is Wrap.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
To display the events in the log, go to the next procedure.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Switch
User: Manager 11:20:02 02-Jan-2004
Event Log
1 - Event Logging..............Enabled
2 - Log Full Action............Wrap
3 - Display Output.............Temporary (Memory)
4 - Display Order..............Chronological
5 - Display Mode...............Normal
6 - Display Severity...........E,W,I
7 - Display Module.............All
C - Clear Log
S - Save Log to File
V - View Log
R - Return to Previous Menu
Enter your selection?