beautypg.com

Jupiter to sms 7000 connections, Software configuration – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 88

background image

Hardware Installation

2−16

VM 3000 Installation and Operating Manual

JUPITER TO SMS 7000 CONNECTIONS

The VM 3000 can be connected to a Grass Valley SMS 7000 Signal Management System and router (see Figure 2−16). The
protocol setting is: 38400 baud, 8 data bits, no parity, 1 stop bit.

The serial cable on the back of the SMS 7000 controller frame may be labeled RS−232, but it can and should function as
RS−422 if configured in software. The VM 3000 is connected to one of the DB25 or DB9 ports on the back of the SMS 7000
controller frame. Refer to the manual supplied with the SMS 7000 for instructions on setting the port up for RS−422 and set-
ting the serial parameters.

Figure 2−16. Connection to SMS 7000 Control System.

See page 2−17 for a description of this cable

GNP protocol

to Series 7000 routing switcher

SMS 7000 control system

House time

code

(optional).

See pg.

2−110

Odd serial port

VM 3000
System
Controller

Software Configuration

The VM 3000 connected to the SMS 7000 must be configured using the Network Description table (page 5−22) and Serial
Protocol table (page 5−25).

The router must be defined on the Switcher Description table (page 5−31). From that point, switcher inputs, outputs, a CP
Level Set, and CP input/Output Sets must be defined.

This manual is related to the following products: