See note 1, See note 2, Es (see note 3) – Grass Valley VM 3000 System Controllers v.7.4 User Manual
Page 70: Es (see note 4, See note 5, See notes 6 and 7, Es (see note 8)

Introduction
1−32
VM 3000 Installation and Operating Manual
Software package
Notes
JUP−SW 2500
JupiterLE
JUP−SW 3100
JupiterPlus
JUP−SW 4000
AccuSwitch
See Note 1
JUP−SW 3500
JupiterXPress
Software Control Panel Suite (GUI)
Option
Option
Option
Option
Party line CP interface
No
Yes
No
No
Tally/UMD
Jupiter Source Tally/UMD
with SlimLine UMD Series
Yes
Yes
No
Yes
See Note 10
Jupiter Source Tally with
RP 1/2/3 UMDs
Yes
Yes
No
Yes
Jupiter Source Tally with
SD 31/32/33
Yes
Yes
No
No
Andromeda tally &
GPIO management
Option
Option
No
Option
TSL Tally/UMD
Yes
Yes
No
Yes
Image Video Tally/UMD
Yes
Yes
Yes (ASCII)
Yes (ASCII)
VTR control protocol
Ampex, ES−Bus
No
Yes
No
No
Sony
No
Yes
No
Yes
TCS machine control
No
Yes
No
No
MI 3040 Machine Control
Yes
Yes
No
No
JNS Control System User Apps
Yes
Yes
Yes, except CP I/O,
Saturn Follow and
PL Download
Yes, except
Saturn Follow
and PL Down-
load
Notes:
1. For additional AccuSwitch and JupiterXPress information, refer to the CM 4000 manual.
2. JupiterXPress and AccuSwitch cannot be downloaded and executed in the same CM at the same time.
3. AccuSwitch cannot execute in a VM/SI but can operate in a network that includes a VM/SI.
4. JupiterXPress cannot execute in a VM/SI and cannot be operated in a network that includes a VM/SI.
5. Except for Triton, matrixes larger than 256 x 256 are an extra−cost option for serial control (“Remote”) routers.
6. Pathfinding is supported between CM−controlled routers provided that the CMs are running the same application (e.g. both are
running JupiterXPress or both are running AccuSwitch). Pathfinding is not supported between a VM−controlled router and a CM−
controlled router.
7. Data level pathfinding is not supported by any Jupiter system.
8. Only switches on routers directly connected to a CM running AccuSwitch can be guaranteed to be frame accurate.
9. Each “remote” router protocol is available as a separate option.
10. For the SlimLine UMD−UD/19, only the triple display mode is supported (i.e., 3 groups of 8 characters each).