Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 236)

Configurator Serial Protocol Table
5−26 VM 3000 Installation and Operating Manual
ENTERING PROTOCOL FOR CONTROLLER BOARD PORTS
1. On the top of the Jupiter Configurator window (page 5−2), check to see whether the configuration set you want to
change is selected for editing.
In most cases, you will want to modify the set that is currently active; if so, you may want to copy the active set and
select the copy for editing. For more information, please see Copying a Configuration Set for Editing on page 5−10.
2. Click on “Jupiter > Serial Protocol.” This will open a table similar to that shown on page 5−25. The Board names should
already be present (they were established using the Network Description table—see page 5−22).
3. Double−click on the appropriate protocol box. A pull−down menu will list the possible protocol types. Click on the
desired type. To accept the entry, double−click again.
Guidelines for using the editor are found on page 5−3.
4. Continue the process for the baud rate fields.
Baud rates will be selected automatically for some protocols. The possible selections are as follows (NA = not available,
Opt = optional, Std = default):
Figure 5−19. Serial protocol selections.
Device type Protocol 1200 2400 4800 9600 19200 38400 115000
Abekas 200 NA NA Opt Opt Opt Std NA
ASCII ASC Opt Opt Opt Std Opt Opt Note 1
Alpha Image ALP NA NA NA NA NA Std NA
Ampex AMP NA NA NA NA NA Std NA
Automation Note 2
CM ES Tributary CET Opt Opt Opt Opt Opt Std Opt
Datatek DTK NA NA NA NA NA Std NA
DD (Diamond) DIM NA NA Opt Opt Opt Std NA
DEC DEC Opt Opt Opt Opt Opt Std NA
Dune DUN NA NA NA NA NA Std NA
ESbus ES NA NA NA NA NA Std NA