Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 299)

Configurator CP Output Set
5−89 VM 3000 Installation and Operating Manual
16. DD (“Diamond”) − serial
For the Serial table, you will need entries similar to those shown in Figure 5−67.
Figure 5−67. Serial Input Set menu.
1
Output Set − ASC−OUT
2 2
3
Entry
DD01
DD02
Output
3
4
DD03
4
5 5
6 6 DD06
DD04
DD05
1
Logical
a. Specify the desired Entry (unit) number.
Note: These Entry numbers must match the numbers assigned to the six buttons of the DD Delegation
Bus, using the DD “Install > Extern Aux > Config” menu. As a convention, these buttons are assigned
Entry numbers from 1 to 6. This will allow the DD operator to control up to six router outputs (these
router outputs are wired into the DD as inputs). Refer to the DD installation manual for information
about the DD serial ports and operating instructions.
b. Enter the name of the first router Output that is wired to the DD. The source of these names is the Switcher Output
table (page 5−51).
c. Enter the next Entry number and Output name, up to the maximum of 128 rows.
When finished, skip to Step 20.