Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 589

Software Control Panel Suite

7−25

VM 3000 Installation and Operating Manual

For more information, see “To Status a Destination” above.

Select the Source button.

The Categories section will be rewritten to display all categories available to the operator.

Select the desired Source Category button.

The Source Entries section will be rewritten to display up to 24 source buttons. Additional Source buttons, if avail-
able, are accessed by using the scroll buttons.

Select the desired “Source Entries” button.

The source entry will be entered into the Preset display.

Select Take to execute the switch.

The Status display will change to the new source indicating the switch was made. The Preset display will change
to the previously selected source. Flip−flop switching between the old and new source is accomplished by pressing
the Take button again.

Paths Full / Protected / Locked / Excluded Messages − see page 7−8.

This manual is related to the following products:

SI 3000 System Controllers v.7.4 CM 4000 Control Module v.7.4