Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 183)

Hardware Installation
2−111 VM 3000 Installation and Operating Manual
Connection to Saturn Master Control Switcher
The Jupiter control system can be used as part of a Saturn Master Control Switcher installation, as shown in Figure 2−127.
§
Jupiter and Saturn software programs are presently supplied on a multi−disk set, and running the “Install” program loads both
Jupiter and Saturn code.
Saturn software is accessed using the “Saturn” pull down menu. See Figure 2−126.
Figure 2−126. Jupiter/Saturn
Configuration menu.
Before attempting to connect and configure the Saturn Master Control Switcher, the Jupiter Facility Control System should
first be installed and checked out.
For Saturn installation instructions, including hardware connections and entries to Jupiter configuration tables, please refer
to the Saturn Master Control Switcher Installation and Operation Manual, Grass Valley part no. 04−046654−010.
The Saturn Tally system, which operates only with the Saturn internal matrix option, is described in the Saturn installation/
operating manual. For Jupiter Tally applications, where signals are followed through routers or production switchers, refer
to page 2−113 of this manual.
For Under Monitor Display installation instructions, see page 2−127.
For parallel control of machines (such as audio carts), using the MI−3040T General Purpose / Tally Interface, refer to page
2−100.
§ Some of the functions described in this section may be extra−cost options. For more information, see page 1−29.