Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 328)

Configurator MPK Devices
5−118 VM 3000 Installation and Operating Manual
MC 3040 (MI 3040) ENTRIES
Non−Grass Valley Machine Control Panel or Computer Applications
With the MI 3040 General Purpose / Tally Interface, a non−Grass Valley machine control panel or computer can use the Jupiter
system to transmit commands to and receive status from a VTR or similar machine. In this application, the MI 3040 is config-
ured in software as an “MC 3040.”
Note: The MC 3040 and MI 3040 hardware is identical.
The following example applies to an “MC 3040/4,” that is, an MI 3040 configured to control four functions (Play, Stop, Ready,
and Cue) for up to 10 control panels. For system drawings, see pages 2−104 and 2−107.
MC3040 MC3040/4 SI1 5 00000040 1
MPK Devices
MPK
Expansion
Pass
Board Port Address Input Sets Output Sets Level Set Overide Set Sequence Set Devices word In Panel Out Panel
Figure 5−94. Entry for MC 3040.
Device
Type
Entries will also be required on the Machine Control table (page 5−146).