beautypg.com

Y line table − vtr controller/tributary selection – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 720

background image

Venus DM 400/400A

L−8

VM 3000 Installation and Operating Manual

Y LINE TABLE − VTR CONTROLLER/TRIBUTARY SELECTION

Note: These instructions assume that the installer has read “Data Matrix Installation” in Section 3 of the Venus
Routing Switcher System Technical Manual
.

Some VTRs can act as controllers or tributaries. These can be connected with a “Y” cable to two Venus ports— one for use
when the VTR is a controller, the other when the VTR is used as a tributary (see Figure L−14). If the VTR is operated only as a
controller, or only as a tributary, then a “Y” cable will not be needed; the cable can instead be one of those shown on page L−4.

The following tables correspond to the system shown in Figure L−14. The basic rules for these tables have already been de-
scribed (starting on page L−3).

1

SAFE

FOR

2

VR1−M

3

VR2−M

REV

192

003

001

003

Switcher Input − DATA

1

Switcher Output − DATA

SAFE

Security

S−T

FOR

016

REV

2

VR1−M

001

3

VR2−M

003

4

5

VR1−S

000

VR2−S

002

001

4

VR1−S

3

VR2−S

002

000

002

000

5

192

Figure L−10.

Figure L−11.

Figure L−12.

Name

Logical Input

Name

Logical Input

Pass
word

1

Switcher Description

2

Switcher

VI

RV

Board

#In #Out PLvL

Follow Level

Driver

3 LI

3 LO

Option

Audio

Level

DM 400

MC

Off Time

DATA

VM1

193 32

16

Binary

E

FOR

DATA

VM1

193 32

16

FOR (DATA)

Binary

E

REV

The Y Line table informs the matrix board (VM 3000 Control Processor) of a level, input, and output that have a Y line
installed. Notice that each Y line requires two entries, and that the “crossover” ports (the “M” ports) are listed as inputs on
the forward level and outputs on the reverse level:

Figure L−13.

Drop−down menu shows

“Switchers” and “Names” from

Switcher Description table

(Figure L−10). Select

appropriate data switcher.

Select the appropriate name from those

already entered on the Input (Figure
L−11) or Output (Figure L−12) table.

1

Y Line Table

Level

REV (DATA)

2

FOR (DATA)

Input

VR2−S

Output

VR2−M

VR2−M

VR2−S

3

REV (DATA)

4

FOR (DATA)

VR1−S

VR1−M

VR1−M

VR1−S

Logical

Logical

This manual is related to the following products: