Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 546)

Control Panel Operation CP 3810
6−126 VN 3000 Installation and Operating Manual
CP 3810 Expansion Panel Operation
The CP 3810 panel can be associated with a CP 3832, CP 3864, CP 3808, or CP 3830 Main panel, providing control of up
to 80 outputs. The CP 3810 can be configured as a “CP 3810L,” allowing it to be assigned to one output; this provides break-
away (split) switching and/or multi−level status. Alternatively, it can be configured as a “CP 3810S,” meaning that the se-
lected outputs will remain selected until explicitly changed by the operator.
The CP 3810 can also be used as a limited−function machine control panel, providing Play and Stop commands for VTRs.
Figure 6−155 illustrates a CP 3810 with a CP 3832 panel.
Note: Even when associated with a CP 3810, the Main panel is still configured independently and can be operated
independently.
VTR1 VTR2 VTR3 VTR4
VTR5 VTR6 VTR7 VTR8
CAM1 CAM2 CAM3 CAM4
CAM5 CAM6 CAM7 CAM8
BLACK BARS TONE CG−1 SILE
NCE CG−2 CG−3 CG−4
EBS1 EBS2 TEST1 TEST2 FDL1 FDL2 FDL3 FDL4
Level Menu Clear
Prot/
Lock Pre−
set Take
CURRENT
PRESET
VTR−001
PLAY/
STOP PLAY/
STOP PLAY/
STOP PLAY/
STOP PLAY/
STOP PLAY/
STOP PLAY/
STOP PLAY/
STOP Take/
Set
Take/
Set
Take/
Set
Take/
Set
Take/
Set
Take/
Set
Take/
Set
Take/
Set Dest
Figure 6−155. CP 3832 with CP 3810 (bottom).
VTR−001 P=01
For a general description of the CP 3810, and hardware installation instructions, see page 2−68. For software configuration
instructions (MPK table), see page 5−136.
To assign CP 3810 buttons to outputs, see page 5−77.
Configuration for machine control applications and the method by which machines are assigned to the panel are discussed
on page 5−156.
MULTI−BUS CONTROL
When configured for multi−bus control, the status of eight buses will normally be seen in the CP 3810’s eight−character dis-
play windows. The “page” of status of eight destinations can be scrolled with the arrow buttons to display up to 80 possible
destinations; the current page number is shown in the window above the DEST button.
To verify destinations − For the CP 3810, press DEST; the destinations will be shown in the eight display windows. The
“page” of eight destinations can be scrolled with the arrow buttons to display up to 80 possible destinations. To return to status
mode, press DEST again. For the Main panel, press MENU, then CLEAR.