Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 261)

Configurator Switcher Output Table
5−51 VM 3000 Installation and Operating Manual
Switcher Output
The Switcher Output table performs much the same function as the switcher input table (described on page 5−44) except that
it applies to outputs.
1
Switcher Output − MAINROUT
Name
MAT MON
Security S−T
−
VIDEO
000
2 MC QC − 001
3 PATCH 1 − 002
4 PATCH 2 − 003
Pass
5 SHOP − 004
6 VC 2P 1 − 005
7 VC 2P 2 − 006
8 VC 2P 3 − 007
word
LEFT
000
001
002
003
004
005
006
007
RIGHT
000
001
002
003
004
005
006
007
TC
000
001
002
003
004
005
006
007
9 VC 2P 4 − 008
6 VC 2S − 009
7 VT 01 − 010
8 VT 02 − 011
008
009
010
011
008
009
010
011
008
009
010
011
Figure 5−37. Switcher output table (example).
Logical Output
Password 5−17
Network Description 5−22
Serial Protocol 5−25
Switcher Description 5−31
Switcher Input 5−44
Switcher Output
Control Panel Sets
Level set 5−55
Input set 5−58
Output set 5−76
Override set 5−98
Sequence set 5−101
Category set 5−103
MPK Devices 5−109
Machines 5−140
Protocol Dependent 5−143
Machine Control 5−146
Delegation Groups 5−159
TCS−1 Device Codes 5−166
Party Line 5−167
Status Display Header 5−170
VGA Status Display 5−171
Tally 5−172
Path Finding 5−194
Exclusion 5−208
Y Line 5−209
Logical Output
Name
The table is used to give each physical output a logical name up to eight characters in length. If
more than one switcher is in the system, a table must be defined for each. Figure 5−37 shows a table for
switcher “MAINROUT.”
Unlike the Switcher Inputs table, the outputs table has several provisions for security:
Security
A Security Board can be identified for an output by entering the name of a controller board (such as
“VM1”); only controls connected to that board could be used to switch the output. The name must be one of
those already entered on the Network Description table (page 5−22).