beautypg.com

Network description table – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 566

background image

Software Control Panel Suite

7−2

VM 3000 Installation and Operating Manual

S Network Description table
S Serial Protocol table
S MPK Devices table
S Machine Control Devices table

These entries are described on the following pages. Guidelines for using the table editor are found on page 5−3.

For information about management of Configuration Sets, including compiling and activating sets, see page 5−8.

NETWORK DESCRIPTION TABLE

Network Description

Redn

Board Name

PC1

PC

Address

1

Type

192.168.253.2

Figure 7−1.

Board Name

Create a name for the PC that will display the Software Control Panels.

For Jupiter naming rules, see page 5−7.

Type

Select board type “PC.”

Address

Enter the IP address of the PC (e.g., “192.168.253.2”).

To find out the IP address, go to Start > Programs > Jupiter Network Suite > JNS Configuration.

In some cases, there may be two network cards installed—one for Jupiter and another for a facility LAN.
If you are not sure which address is correct for the Jupiter card, try looking at Network Neighborhood >
Properties (right click for Properties), then Protocols > TCP/IP Protocol > Properties > Adapter; usually
the Jupiter card will be a 3Com. Click on 3Com to see the IP address of the card.

This manual is related to the following products: