Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 136)

Hardware Installation
2−64 VM 3000 Installation and Operating Manual
Hardware Installation
Installation of this panel is shown on page 2−50.
If desired, the panel hardware can be tested, and window/button brightness adjusted, without being connected to the controller
board (such as a VM/SI 3000). For more information, see Diagnostics Mode on page 6−112.
Software Configuration
The panel uses an eight−character CP Level Set of type “3800” (page 5−55).
MPK table entries will depend on the application (see page 5−109).
Sources are defined in a CP Input Set of type “cp3832” (page 5−58). Destinations are defined in a CP Output Set of type
“cp3832” (page 5−76).
Before the panel can be used, these sets must be compiled, and the appropriate configuration set made active using the Control
Center (page 5−13).
For CP 3832 operating instructions, see page 6−100.
For CP 3832L operating instructions, see page 6−117.