Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 435)

Control Panel Operation CP 3000
6−15 VM 3000 Installation and Operating Manual
Switching Different Inputs with a Single TAKE Command
By using the procedure just described, a completely different input can be selected from one level to another before pressing
TAKE.
1. Select an input without pressing TAKE.
2. Press LEVEL.
a. If you want to de−select a level, press the appropriate function key now.
3. Select another input.
4. Press LEVEL, then press the Function key for the level(s) you want to receive this input.
5. Repeat as needed for other levels.
a. If you de−selected a level (in Step 2a. above), you must press the appropriate function key again to blank the entry.
6. Press TAKE.
An Alternate Method of Split Switching
When only one level is to be switched, you may find it convenient to use the following method:
1. Press LEVEL.
2. Use the desired Function key to toggle the level ON.
3. Select an input.
4. Press TAKE.
If entry of a password is requested, please see Passwords on page 6−22.
MENU SELECTIONS
The operator uses MENU and MORE to display the desired menu selection. (See Figure 6−17.) The corresponding Function
key is used to select the desired operation.