Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 582)

Software Control Panel Suite
7−18 VM 3000 Installation and Operating Manual
Switching using the Categories/Source Entries section remains active.
Memory
The memory window allows the user to save or recall up to four sets of 12 Direct Take setups.
Saving a Direct Take Setup
Note: Saved presets for a given configuration set may not be valid with other configuration sets. For example, if
a preset calls for input ”VTR1” and “VTR1” does not appear in a set downloaded at a later time the preset will fail.
1. Follow the Direct Take Preset Assignments procedure above to set up the Direct−Take selections to be saved.
2. With the Direct−Take window open, select the Memory button.
The Memory button label color will change from white to red and the Memory window will appear.
Figure 7−12.
3. Select the desired Memory location (1, 2, 3, or 4).
The label will change from black to yellow.
4. Select Store.
The setup will be saved in the selected location. Also, a “Recall” and a “Clear” button will now appear.