Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 294)

Configurator CP Output Set
5−84 VM 3000 Installation and Operating Manual
The 15−category factory default set used for CP 3824 panel is as follows:
VTR CG NET VCR CAM
AUX SS REM FILM PTCH
STU TEST SAT FS MISC
The 12−category factory default set used for the CP 3830 and CP 3830P panels is as follows:
VTR GFX Studio
ENG REM NET
EC POST Xmsn
AUX TEST NUM
Guidelines for using the editor are found on page 5−3.
b. Specify the desired Entry (unit) number. This can be done by double−clicking on the desired “Entry” field and
typing the number. Press ENTER.
c. Select the Output name.
The source of these names is the Switcher Output table (page 5−51).
Note 1 The CP 3830P controls two outputs, a “Current” output and a “Preview” output; both of these
outputs can be selected at the front panel at any time (as described on page 6−89). Once selected, these
outputs will remain in effect until changed by the operator or PMEM is cleared.
Note 2: At startup, the two outputs controlled by a CP 3830P will be the first two entries in the compiled
CP Output Set. During compile, the system will refer to the CP Category set that applies to the CP
3830P; typically this will be the 12−category default set shown on page 5−83. Since the first category is
“VTR,” the system will check for the first CP Output Set entry in that category; this will be the first entry
in the compiled table and therefore the default Current output. The second entry in the VTR category
will be the default Preview output, etc.
d. Check the Auto Mnemonic box or enter the desired Mnemonic.
The Auto Mnemonic function can be used to enter a control panel mnemonic automatically based on the Name
given to the output. In cases where the output Name is more than four characters long, the mnemonic will be trun-
cated to the first four characters.
If an Output Name is changed on the Switcher Output table and Auto Mnemonic is enabled, the mnemonic will
change to the new name automatically.
Note: if you use the Auto Mnemonic feature, it will not work if you go back to a version of the Jupiter
editor prior to 6.2.1.
A CP 320 panel can display four−character mnemonics; the CP 328, CP 3808, and CP 3830 can display eight−char-
acters.