beautypg.com

X−y application (no split panel), 64 x 32 control station, Figure 5−112 – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 344

background image

Configurator

MPK Devices

5−134

VM 3000 Installation and Operating Manual

X−Y APPLICATION (NO SPLIT PANEL)

64 X 32 control station

MPK bus

VM 3000
“VM1”

Destination Panel

“CP3832”

64

sources

32

destinations

Source (Main) Panel

“CP3864”

Figure 5−112.

CP3864

CP−3864

2

00000043

3832−IN

3832−OUT

CP3832

CP−3832

2

00000044

1

MPK Devices

MPK

Expansion

Pass

Board

VM1

Port

Address

Input Sets

Output Sets

Level Set

Overide Set

Sequence Set

2

VM1

KXYZ−LEV

Devices

word

In Panel

Out Panel

Note: Assignment of specific CP sets to a panel
identifies it as the “main” panel.

Figure 5−113. Entry for system shown in Figure 5−112.

CP3864

Device

Type

In this example, the CP 3864 is being operated as a source and “main” panel and the CP 3832 is being operated as a destination
panel.

The top CP 3864 is considered to be the “main” panel because it controls the inputs; therefore it will be assigned to specific
CP sets. Enter the name of the CP Input and CP Output Sets that will be used to assign inputs and outputs to all the buttons
at this control station. See page 5−58 (CP Input Sets) and page 5−76 (CP Output Sets).

Any additional source panels would refer to the main panel (the CP 3864 in this example) in their In Panel column. They
would use the CP sets assigned to the main panel. The first input expansion panel listed in this table will have the button num-
bers immediately following those of the main panel; the next input expansion panel listed will have the next higher set of
button numbers, etc.

For the CP 3832 in this example, use the Out Panel column to select the MPK Device name of the main panel. If additional
panels are added to provide more destinations, they would also refer to the main panel (the CP 3864) in their Out Panel col-
umn; they would use the CP sets assigned to the main panel. The first output panel listed in this table will have the lowest−num-
bered set of buttons; the next output panel listed will have the next higher set of button numbers, etc.

MPK Device table entries for other CP 3832/64 applications was discussed on page 5−111 and following.

This manual is related to the following products: