Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 474)

Control Panel Operation CP 3800
6−54 VN 3000 Installation and Operating Manual
ÎÎÎ
ÎÎÎ
ÎÎÎ
OVER
RIDES
OVERRIDE MODE (CONT’D)
1 Some Override Levels Not Valid For Destination − Partial Take Occurred
ALLBLACK ALL_BARS SET_UP_A SET_UP_B OVERRD05 OVERRD06 OVERRD07 OVERRD08
Figure 6−76. Example Override Mode Warning Display.
1 All Override Levels Not Valid For Destination − No Take Occurred
ALLBLACK ALL_BARS SET_UP_A SET_UP_B OVERRD05 OVERRD06 OVERRD07 OVERRD08
Figure 6−77. Example Override Mode Warning Display.
Defining Overrides
Users may define overrides to any unused accessible location. Overrides defined from the Jupiter file server CANNOT be
changed as they do not contain audio modes. User defined overrides do contain audio modes.
Overrides are automatically named by their position. For example, creating an override for the 2nd button of the third page
will create an override named “OVERRD18.” User defined overrides may also be erased if no longer needed or to make room
for new definitions.
Entering Define Mode
The panel is placed in Define Override mode by selecting a destination and double punching the OVERRIDE button. It will
illuminate in red to indicate this mode. The display will indicate this mode and prompt for a button assignment (valid soft
key locations will illuminate in green). A blank page will be provided after the last page of overrides.
1 Defining Override − Use Up/Down Buttons And Soft Key To Select Position
ALLBLACK ALL_BARS SET_UP_A SET_UP_B OVERRD05 OVERRD06 OVERRD07 OVERRD08
Figure 6−78. Example Home Defining Override Menu.
Creating the override definition
When the user has selected an appropriate location, that soft key will illuminate in red and the display will indicate the selec-
tion and that it is ready to record the override:
3 Defining Override − Select TAKE to Define − 2ND TAKE to Finish
TST_OR17 TST_OR18 OVERRD20 −DEFINE−
Figure 6−79. Example Override Definition Menu − Page 3, Fifth Button Position Selected.
When this menu appears the user may deselect the red soft key or select CLEAR to return to the Home Defining Override
menu or may deselect the red OVERRIDE button to exit Defining mode.