Equipment dimensions, 10 base 2 network, Pc 3000 specifications (minimum) – Grass Valley VM 3000 System Controllers v.7.4 User Manual
Page 53: Vm/si 3000 control processors, Cb 3000 control buffer

Introduction
1−15
VM 3000 Installation and Operating Manual
10 BASE 2 NETWORK
Type: Ethernet thin cable (thin net)
Cable: RG−58 A/U or RG−58 C/U
Connectors: BNC (50 ohm)
Transmission speed: 10 Mbits/sec
Max segment length: 185 m (607 ft) (expandable through repeaters)
Max nodes per segment: 30
File server: Grass Valley PC 3000 System File Server
PC 3000 SPECIFICATIONS (MINIMUM)
S Intel Pentium 700 processor with 256 K L2 cache
S 512 Mbytes RAM memory
S 1.2 Gigabyte hard drive
S 4X CD−ROM drive
S 1.44 Mb floppy drive
S Intel or 3Com Ethernet LAN card
S Media converter or hub if needed to connect Ethernet LAN card to CM 4000 or to Jupiter VM/SI 3000. (The
CM 4000 has a 10/100baseT rear panel connector; the VM/SI 3000 has a 10base2 rear panel connector.)
S Keyboard / mouse
S 15−inch monitor capable of 1024x768x256
S 2 serial ports and 1 parallel port
S Windows 2000 Professional or XP Professional
A Site License is required to enable features; see Ordering Information (page 1−23).
Jupiter software is installed and tested.
Use of a customer−supplied computer is discouraged (to avoid compatibility problems due to evolving software require-
ments). If circumstances require a customer−supplied computer, please contact Grass Valley technical support.
EQUIPMENT DIMENSIONS
VM/SI 3000 CONTROL PROCESSORS
1.75 in. high x 19 in. wide x approx. 17.5 in. deep (44 x 483 x 445 mm)
CB 3000 CONTROL BUFFER
1.75 in. high x 19 in. wide x 16.75 in. deep (44 x 483 x 425 mm)