beautypg.com

Error messages, Tie line status and operation, Tie lines used up warning – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 483

background image

Control Panel Operation

CP 3800

6−63

VM 3000 Installation and Operating Manual

TIE LINE STATUS AND OPERATION

All destinations employing tie lines will be so indicated with a blinking “T” in the destination status display in the 1st character
position. When in single destination mode, the 1st character position of each level will also reflect tie line status with the blink-
ing “T.”

Tie Lines Used Up Warning

Any time a Take is attempted that requires a tie line connection but none are available, the following display will appear show-
ing the name of the destination, its current source, and the attempted source:

1

NO TIE LINES LEFT TO SWITCH PRODCTN4 to OuterSpc

VTR_0123 VTR_0124 VTR_0125 VTR_0126 STUDIO_A STUDIO_B ENGINRNG PRDCTN4

Figure 6−100. Example Tie Lines Used Up Warning Message − Multi Destination Mode.

This display will remain for an undetermined timeout or until the CLEAR button is selected, which ever comes first. If the
take is to multiple destinations via multiple destination mode or a sequence, as much of the operation requested as is possible
will be performed. If multiple tie line requests were not fulfilled, multiple warnings will stack up and be displayed consecu-
tively.

As required, this tie line warning will appear during normal takes, overrides and sequences. When this condition occurs, all
levels of switching for the particular take will occur for those levels which can (those that do not require tie lines or still have
tie lines available). Sequences will execute all other takes that can be completed.

ERROR MESSAGES

For an explanation of CP 3800A series error messages (such as “10xx” or “3200” or “80xx”) please refer to Appendix S.

This manual is related to the following products: