Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 300)

Configurator CP Output Set
5−90 VM 3000 Installation and Operating Manual
17. GVG 200 − E−MEM
For Grass Valley E−MEM applications, a special CP Output Set is used to list the outputs of the routing switcher that
are used as inputs to the production switcher. The Jupiter system can be told to take a snapshot of these outputs and
restore them at a later time (see page 2−88).
If you are entering a set for GVG 200 E−MEM, you will need a table similar to that shown in Figure 5−68.
1
Output Set − GVG−OUT
dflt
2 dflt
1
2
Category Entry
GV01
GV02
Output
3 dflt 3 GV03
4 dflt
5 dflt
4
5
6 dflt 6 GV06
7 dflt 7
8 dflt 8 GV08
GV04
GV05
GV07
n dflt n GVNN
Figure 5−68. Output Set table (example).
Logical
For Category, the word “dflt” is used for all entries.
The Entry number is used by the Grass Valley switcher to refer to a routing switcher output shown in the Output column.
In this example, Entry No. 1 has been assigned to the routing switcher output named “GV01.” The source of the Output
names is the Switcher Output table (page 5−51).
When finished, skip to Step 20.