beautypg.com

Software configuration, Redundant installation – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 92

background image

Hardware Installation

2−20

VM 3000 Installation and Operating Manual

Software Configuration

The VM 3000 connected to the Encore must be configured using the Network Description table (page 5−22) and Serial Proto-
col table (page 5−25).

When Jupiter is controlling Encore, the Serial protocol setting is: GNP (Grass Valley Native Protocol), 9600 baud.

The router must be defined on the Switcher Description table (page 5−31). From that point, switcher inputs, outputs, a CP
Level Set, and CP input/Output Sets must be defined.

Note: If Encore is controlling Jupiter, different software settings are required. See page 2−82.

Redundant Installation

Some Encore systems may be equipped with redundant System Controller Boards (SCBs). In this case, the recommended
arrangement is to install a redundant VM 3000 and connect the VMs to the SCBs with a double−Y cable. See Figure 2−23.

Figure 2−23. Connection to redundant Encore Control
System. See following figures for cable variations.

to routing switcher

Encore Redundant SCBs

Odd serial ports

Redundant VM 3000
System Controllers

RS−422
ports

Details of the Encore connection are presented below.

Information about other cables used in redundant VM installations is found on page 2−4 and following.

This manual is related to the following products: