beautypg.com

Entering or editing a cp input set – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 272

background image

Configurator

CP Input Set

5−62

VM 3000 Installation and Operating Manual

ENTERING OR EDITING A CP INPUT SET

(Includes procedure for assigning category/numbers or mnemonics)

1.

On the top of the Jupiter Configurator window (page 5−2), check to see whether the configuration set you want to
change is selected for editing.

For more information, please see Modifying and Downloading a System Configuration Set on page 5−8.

2.

Click on “Jupiter,” “Control Panel Sets,” and “CP Input Set.” This will open a list of all existing CP Input Sets.

Figure 5−43. Select CP Input Set menu.

3.

If you want to create a new set, click on “New,” and go to Step 4. Or, if you want to edit an existing set, click on the
name of the Input Set; then click “Open Table” and skip to Step 7.

You can also double−click on the name of an existing set to open the table.

If you want to copy an existing CP Input Set for use with a different panel type, you can probably save a lot of time by
following the procedure described on page 5−74.

4.

If you are creating a new set, you will be asked to name the set.

Guidelines for using the editor are found on page 5−3.

Important: Do not use the same name for different CP sets. Also, do not name a CP set with a name used
by the system for a Device Type. Device Type names are entered on the MPK Devices table (page 5−109).
Device Type names are shown on page 5−110.

5.

If you want to assign this CP Input Set to a custom CP Category set (for a panel with re−legendable keycaps), enter the
custom CP Category set name. (If you wish to create a custom category set, skip to page 5−103 and then return to this
subsection.)

This manual is related to the following products: