beautypg.com

Cp 320 push button control panel, Cp 328 push button control panel, Cam1 vtr2 vtr1 – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 125

background image

Hardware Installation

2−53

VM 3000 Installation and Operating Manual

CP 320 Push Button Control Panel

Installation of this panel is shown on page 2−50.

Figure 2−61. CP 320 Push Button Control Panel (as supplied).

CHG
OUT

CHG

VID

CHG

A1

CHG

A2

CHG

A3

CHG

A4

CHG

A5

DESTINATION

SELECTION

STATUS

CAM1

VTR2

VTR1

VTR

1

CG

2

NET

3

VCR

4

CAM

5

AUX

REM

6

FILM

7

PTCH

8

STU

9

TEST

0

EJ

SS

MISC

FS

SAT

TAKE

PROT

The CP 320 is a full−matrix, category/number control panel. The left-most mnemonic display shows switcher destination
(output being controlled), the center display shows the input category/number just selected, and the right indicates switcher
status (input now switched to the destination shown).

Sixteen buttons in the center are labeled with input/output categories; this allows the first button press to designate the cate-
gory and the second button press to designate the selection number. The factory−supplied categories (“VTR,” “CG,” etc.) can
be changed by installing new labels (see page 2−77) and creating a custom category set (see Step 5 on page 5−62.)

Two buttons are located on the far right, the top button for protecting an input and the bottom button for performing a TAKE
of the selected input/output. Buttons are also provided for changing the output to be controlled and for selection of specific
levels (split switching).

The CP 320 panel is configured using the MPK Devices table (page 5−109). For operating instructions, see page 6−3.

CP 328 Push Button Control Panel

Hardware installation and operation of the CP 328 is the same as the CP 320. Software configuration is slightly different due
to the eight−character display windows. See Step 10 on page 5−65.

This manual is related to the following products: