Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 350)

Configurator Machines Table
5−140 VM 3000 Installation and Operating Manual
Machines
hexadecimal
1
Machines
2
VT01 Sony Mch SI1 1
VT05 Ampex Mch SI1 7 80A2
Figure 5−124. Machines table for system shown on page 5−142.
Name Type
Board Port Address
Machine Device
Password 5−17
Network Description 5−22
Serial Protocol 5−25
Switcher Description 5−31
Switcher Input 5−44
Switcher Output 5−51
Control Panel Sets
Level set 5−55
Input set 5−58
Output set 5−76
Override set 5−98
Sequence set 5−101
Category set 5−103
MPK Devices 5−109
Machines
Protocol Dependent
5−143
Machine Control 5−146
Delegation Groups 5−159
TCS−1 Device Codes 5−166
Party Line 5−167
Status Display Header 5−170
VGA Status Display 5−171
Tally 5−172
Path Finding 5−194
Exclusion 5−208
Y Line 5−209
This table is the source for information about machines using Sony or Ampex serial protocol. Data entered here is automatical-
ly made available on the Machine Control table.
§
Important: Row numbers on Jupiter tables are used as the “logical” numbers for devices. Changing the row num-
ber of an existing device (by inserting/deleting a device in the middle of the table, for example) will disrupt con-
trol of the machine, requiring linkages to be reestablished. One way to avoid this interruption is to add new de-
vices at the end of tables.
Name
This column lists the device names of all serial control machines in the system.
This is the source for machine names that appear on the control panels. Although this field will accept eight
characters, you may wish to limit machine names to four since that is the maximum that can be displayed on
the MC 3000’s expansion panel.
§ Some of the functions described in this section may be extra−cost options. For more information, see page 1−29.