beautypg.com

Switcher input tables, For example, figure 5−171, Shown in figure 5−171 – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 406

background image

Configurator

Path Finding

5−196

VM 3000 Installation and Operating Manual

SWITCHER INPUT TABLES

Referring to Figure 5−172 and the Switcher Input table for “NEWSROUT,” the entries for VT21 and VT22 follow the normal
pattern. However, there are also entries for VT15 and VT16—machines that are normally sources for “MAINROUT.” In the
following columns, there are Group Name selections such as “VNEWMAIN,” “LNEWMAIN,” etc. If there is a request for
VT15 to be switched to a “NEWSROUT” output, then the system is referred to Groups VMAINNEW through TMAINNEW
on the Path Finding Data table. The VMAINNEW entry, for example, shows that for video there are three tie lines available
to make this switch. Assuming that one of these lines is available, the switch will be completed.

Note: All sources identified as available through path finding must also appear on the Switcher Input table for the
“home switcher.” In the example just given, VT15 appears on both tables.

17 18 19 20 21 22 23 24 25

6

7

8

9

10

11

12

13

14

38 39 40 41 42 43 44 45 46 47 48

55

56

57

58

59

60

61

62

63

64

Distribution

switcher

“NEWSROUT”

Distribution

switcher

“MAINROUT”

65

VT16

VT15

VT22

VT21

Figure 5−171. Example of sequential path finding connec-
tions between video levels of two switchers. For correspond-
ing tables, see Figure 5−172.

In this example, this group of tie
lines is named “VNEWMAIN” (vid-
eo, NEWSROUT to MAINROUT).
Other naming schemes could use
“GROUP1,” or, more elaborate
names like “V5N10M43,” meaning
“Video, 5 News lines starting at
output 10 to Main router starting
at input 43,” etc.)

In this example, this group of tie
lines is named “VMAINNEW.”

This manual is related to the following products: