beautypg.com

Cp 3830p (cp 3830 with automatic preview), Cp 3809 expansion panel, Hardware installation – Grass Valley VM 3000 System Controllers v.7.4 User Manual

Page 133: Software configuration

background image

Hardware Installation

2−61

VM 3000 Installation and Operating Manual

CP 3830P (CP 3830 with automatic preview)

The CP 3830 can be configured to control two outputs with the second output used for preview. In this mode, the panel is
referred to as a “CP 3830P.” To take full advantage of this capability, a video preview monitor should be located near the panel.
Note: The CP 3830P cannot be operated with an expansion panel.

The CP 3830P panel uses a CP Level Set of type “3800” (page 5−55), a CP Input Set of type “3830” (page 5−63), and a CP
Output Set of type “3830” (page 5−80). These sets are among those assigned to each panel using the MPK Devices table (page
5−109); where the panel is identified as a CP 3830 type “P.”

For operating instructions, see page 6−88.

CP 3809 Expansion Panel

Up to five optional CP 3809 panels can be associated with a CP 3808 or CP 3830 (but not CP 3830P), providing direct switch-
ing and continuous status for up to 40 outputs.

Figure 2−72 illustrates a CP 3808 with a CP 3809 array for control of 24 outputs.

2

3

4

5

7

8

9

0

6

1

VTR

CG

NET

VCR

CAM

REM

TEST

MISC

AUX

FILM

PTCH

STU

SAT

EDIT

FS

STILL

Take

Clear

Menu

1

STU

2

STU

3

STU

4

STU

8

STU

7

STU

6

STU

5

STU

17

STU

18

STU

19

STU

20

STU

24

STU

23

STU

22

STU

21

STU

VTR−041

CAM−002

Figure 2−72. CP 3808/E (top) with CP 3809/2 Dual Expansion Panel (below).

9

STU

10

STU

11

STU

12

STU

16

STU

15

STU

14

STU

13

STU

Hardware installation

Installation of this panel is shown on page 2−50. Note that each CP 3809 Expansion panel requires a separate MPK connec-
tion.

If desired, the panel hardware can be tested, and window/button brightness adjusted, without being connected to the controller
board (VM/SI−3000). For more information, see Diagnostics Mode on page 6−125.

Software configuration

Each CP 3809 Expansion panel requires a separate entry on the MPK Devices table. See “Out Panel” on page 5−110.

This manual is related to the following products: