Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 230)

Configurator Passwords
5−20 VM 3000 Installation and Operating Manual
Systems are shipped with a password level of 00 for all panels and outputs; therefore any password can initially be used to
access all control panel functions.
As shown in Figure 5−9, there is only one table of passwords, and this table is used no matter what configuration set is active
or selected for editing. However, the password levels for individual control panels and outputs are stored with individual con-
figuration sets.
CHANGING PASSWORDS
1. On the main menu (page 5−2), select “Jupiter” (or ALT+j) to bring up the configuration set table list (Figure 5−15).
As explained above, it doesn’t matter which configuration set is selected for editing, since the password table applies
to all sets.
Password
Network Description
Serial Protocol
Switcher Description
Switcher Input
Switcher Output
Control Panel Sets F8
MPK Devices
Machines
Protocol Dependent
Machine Control
Delegation Groups
TCS−1 Device Codes
Party Line Description
Party Line Input
Party Line Output
Party Line Levels
Status Display Header
VGA Status Display
Tally Relay
Tally Dependency
Sequential Path Finding
Non−Sequential Path Finding
Exclusion
Y Line
CP Level Set
CP Input Set
CP Output Set
CP Override Set
CP Sequence Set
CP Category Set
Figure 5−15. Configuration set table list.
2. Select “Password” (or press “p”). This will display the password table:
1
Password Table
Password
999999
Level
99 Figure 5−16.