Saturn video processor - entry for mpk port, Saturn video processor − entry for mpk port, Figure 5−20 – Grass Valley VM 3000 System Controllers v.7.4 User Manual
Page 240

Configurator
Serial Protocol Table
5−30
VM 3000 Installation and Operating Manual
SATURN VIDEO PROCESSOR − ENTRY FOR MPK PORT
The Saturn Master Control Switcher video processor (either digital or analog) can be used as an alternate connection point
for an MPK bus. (In Saturn stand−alone systems, it would be the only MPK port available.) Typical uses for the MPK bus
include:
S Connection to an MI−3040 General Purpose / Tally Interface (see page 2−112 for a system illustration).
S Connection to the Saturn console’s Select button group. In multi−channel Saturn systems, this would allow
selection of the channel to be be controlled. Please refer to the Saturn Installation Manual for more information.
An example entry is shown in Figure 5−20. The name of the video processor comes from the Network Description table. To
define the processor’s port, select “MPK” and “38400” for the first port pair. All other ports can be left undefined.
2
Serial Protocol
1
AVP
MPK
Board
(CM 1)
Protocol 1/2 -
UND
(CM 2)
Protocol 3/4 -
UND
(CM 3)
Protocol 5/6 -
UND
(CM 4)
Protocol 7/8 -
UND
(CM 5)
Protocol 9/10 -
UND
11/12 - (CM 6)
Protocol
UND
13/14 - (CM 7)
Protocol
UND
15/16 - (CM 8)
Protocol
38400
(CM 1)
Baud 1/2 -
(CM 2)
Baud 3/4 -
(CM 3)
Baud 5/6 -
(CM 4)
Baud 7/8 -
(CM 5)
Baud 9/10 -
(CM 6
Baud 11/12 -
(CM 7)
Baud 13/14 -
(CM 8)
Baud 15/16 -
Figure 5−20.