Grass Valley VM 3000 System Controllers v.7.4 - Manual (Page 493)

Control Panel Operation CP 3808
6−73 VM 3000 Installation and Operating Manual
The “low” green level is used for normal button lighting. “High” green and “high” red are also used, but these are not adjust-
able.
Note: The amber color, which is presently used only for a CP 3830 dedicated output panel, is created by combining
low green and low red.
For each setting, use the UP and DOWN buttons to change to the desired brightness and press TAKE. Press CLEAR to exit.
Burn In
This test rotates through the button lamp and Display tests continually. Press CLEAR to cancel.
Key test
This diagnostic displays the number of each button as it is pressed. Pressing the CHOP key will change the lamp color. Press-
ing CLEAR twice exits.
Display test
This test cycles through and displays all legal characters. The test will stop after one cycle. Pressing CLEAR exits. (On the
CP 3809, press the lower right button to exit.)